1W FM Transmitter Circuit


Posted on Feb 7, 2014

A very good 1 watt fm transmitter circuit, very easy to build circuit. It has 4 transistors, one is a very stable oscillator, followed by a buffer stage to prevent frequency variation when you adjust the transmitter. Next is a resonance stage and the final stage built with a minimum 1W transistor which must have a heatsink. You must use a LM7805 s


1W FM Transmitter Circuit
Click here to download the full size of the above Circuit.

tabilizer for the oscillator diodes and one LM7809 for powering up the T1 oscillator stage. This will give you a very stable transmitter frequency. First build the oscillator stage and the buffer, power it up and trim the 10k linear potentiometer untill you can here a blank signal on your receiver. If you put a small piece of wire on the T2 emitter you can see that the cover range of the 2 stage transmitter is about 3 meter. After you are sure that your oscillator+buffer stage are working properly, remove the power supply and continue building the T3 resonance stage. Connect the power supply and if you adjust the trimmer (variable capacitor) from T3 collector you can see how the fm transmitter power can be varied. This stage is very important for proper functionality of the entire 1 watt fm transmitter. You must adjust the trimmer for maximum power. The final stage of the 1W fm transmitter is built with 2N4427 (recommended) or the transistors from the list. If you can`t find any, use a BD139 transistor but only for frequencies lower than 90 MHz. The output power will be lower but you get the idea. If you decide to use 2N2219 transistor for the final stage of the transmitter you must know that the output rf power will be 0. 4W. Adjust the last 2 trimmers for maximum output power in the antenna. Initially use 2 x 100 © 0. 5W resistors in parallel at the RF output. Then connect this rf probe to the output and adjust all the 3...




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Carrier-current-audio-transmitter
    High-voltage-bucking-regulator
    Power Controller (For Automotive Accessories) Circuit
    Accu charger use a diac and triac Schematic Diagram
    24w amplifier using tda1516
    nicd battery charger schematic
    28 LED Clock Timer
    Vladimir Utkins Free-Energy Secrets
    Variable High Voltage Power Supply
    Single-junction transistor sine wave oscillator circuit
    Use TWH8751 street light control circuit



    Top