2Watt Audio Amplifier


Posted on Feb 5, 2014

The circuit was deliberately designed using no ICs and in a rather old-fashioned manner in order to obtain good harmonic distortion behavior and to avoid hard to find components. The amplifier(s) can be conveniently supplied by a 12V wall plug-in adapter. Closing SW1 a bass-boost is provided but, at the same time, volume control must be increased


2Watt Audio Amplifier
Click here to download the full size of the above Circuit.

to compensate for power loss at higher frequencies. In use, R9 should be carefully adjusted to provide minimal audible signal cross-over distortion consistent with minimal measured quiescent current consumption; a good compromise is to set the quiescent current at about 10-15 mA. To measure this current, wire a DC current meter temporarily in series with the collector of Q3.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    LED Digital gated Emulator using AT89C2051
    Power Mosfet Inverter
    Five-step voltage-level indicator
    Knock Block using an Arduino board
    10hz 60mhz frequency meter
    hygrometer
    stepper motor controller
    3volt fm transmitter for 88mhz
    SF04E emission circuit diagram composed SF04B



    Top