Motor vehicle steering flasher 12


Posted on Feb 5, 2014

The motor vehicle steering flasher described in the example uses high-power transistors as electronic switches, the circuit is simple, easy to make. The working principle The motor vehicle steering flasher is composed of the flash circuit resistors R1-R3. Capacitor C, diode VD, transistors V1, V2, it is shown in Figure 7-21. S is the vehicle turn


Motor vehicle steering flasher 12
Click here to download the full size of the above Circuit.

signal switch; HLl and HL2 are the left turn signal and right turn signal respectively. Before turning signal switch S (in the center), the oscillator circuit composed of vl, v2, and external RC components does not work. Placing S in the L or R position, the oscillation circuit works, V2 makes intermittent conduction with a certain frequency, Ll or HL2 is flashing. Component selection RI-R3 selects 1/4W carbon film resistor or metal film resistors. C uses 25V electrolytic capacitors. VD uses lN5402 silicon rectifier diode. VI selects 3DGl2 or S8050 silicon NPN transistor; V2 uses 3AD30 germanium PNP transistors.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Telephone Light Ringer
    Low-flow-rate-thermal-flowmeter
    13.8Vdc 2A Regulated Power Supply Circuit
    Light sensor using Op Amp
    sound origin direction finder
    TV antenna booster
    Active Filter Design with OpAmps
    Audio VU Meter
    Easy 5V 10A switching regulator by L4970A



    Top