NiMH Battery Charger Circuit

Posted on Feb 7, 2014

A simple battery charger for the Nickel Metal Hydride battery that requires current regulated charging. The charger provides 140 mA current for quick charging of the battery. Power supply section consists of a 0-18 volt AC 1 Ampere step-down transformer, a full wave bridge rectifier comprising D1 through D4 and the smoothing capacitor C1.

NiMH Battery Charger Circuit
Click here to download the full size of the above Circuit.

Current regulation is achieved by the action of R1, R2 and the Epitaxial Darlington PNP transistor TIP 127. Resistor R1 keeps the charging current to 140 milli amperes. LED and resistor R2 plays an important role to control the base current of T1 and thus its output. Around 2. 6 volts drop develops across the LED which appears at the base of T1. Emitter base junction of T1 drops around 1. 2 volts. So 2. 6 1. 2 volts gives 1. 40 volts. So the current passing through R1 will be 1. 40 V / 10 = 0. 14 Amps or 140 Milli Amps. The LED act as the charging status indicator. LED lights only if the battery is connected to the output of circuit and the input voltage is normal.

Leave Comment

characters left:

New Circuits



Popular Circuits

RF probes
Tube Preamplifier with ECC88
Dual voltage power supply 12 volts
LED bar peak program meter display for audio
LED Emergency Light Circuit With Battery Over Charge Protection
Electronic Transformer Applications
LM318 microphone preamplifier circuit design
A muting delay & DC offset protection circuit
8-Channel Air Sampler and Biodetection
Single chip TV chroma luma processor
Based on the LT3755 50W white LED headlight drive circuit diagram
Single-junction transistor a phase-shift trigger circuit