PC Fan Speed Controller - For a Low-Noise PC

  
Inside:
Repository
The fan runs constantly in many PCs, which may not even be necessary. A simple controller circuit can regulate the fan speed according to demand. This not only saves energy, it also reduces irritation from the fan noise. Only three components are needed to allow the fan speed to be controlled according to the actual demand: one adjustable voltage
PC Fan Speed Controller - For a Low-Noise PC - schematic

regulator and two resistors that form a voltage divider. One of the resistors is a NTC thermistor (temperature-sensitive resistor), while the other is a normal resistor. If the 12-V power supply is not located close to the regulator, a decoupling capacitor is also required (see Figure 1). The thermistor has a rated value of 470 . It sets the output voltage of the LM317T to approximately 7 V at 25 C. This should ensure reliable starting of the fan. If the temperature rises to roughly 40 °C, the output voltage of the regulator reaches its maximum value and the fan runs at its maximum speed. The voltage drop across the regulator is at least 1. 75 V for a motor current of (for example) 300mA, and in any case 2V at the maximum current level of 1 A. You thus might want to consider using a low-drop regulator, such as the National Semiconductor LM2941CT. To be sure, this increases the size of the circuit to a full five components, which are arranged as shown in Figure 2. However, this approach reduces the voltage drop to 0. 2 V at 300 mA or 0. 5 V at 1 A. By the way, low-drop voltage regulators are not available in a three-lead package. The circuit can be constructed as a well-insulated free-standing` assembly, or it can be built on a small piece of prototyping board. In either case, it should be fixed to one of the mounting holes of the fan body (via the cooling tab of the TO-220 regulator package for the free-standing...



Leave Comment

characters left:

New Circuits

.