USB Host and Device


Posted on Feb 5, 2014

The DE2 board provides both USB host and device interfaces using the Philips ISP1362 single-chip USB controller. The host and device controllers are compliant with the Universal Serial Bus Specification Rev. 2. 0, supporting data transfer at full-speed (12 Mbit/s) and low-speed (1. 5 Mbit/s). Figure 1 shows the schematic diagram of the USB circuitry


USB Host and Device
Click here to download the full size of the above Circuit.

; the pin assignments for the associated interface are listed in Table 1. Detailed information for using the ISP1362 device is available in its datasheet and programming guide; both documents can be found in the ISP1362 references below. The most challenging part of a USB application is in the design of the software driver needed. Two complete examples of USB drivers, for both host and device applications, can be found in Sections 5. 3 and 5. 4. These demonstrations provide examples of software drivers for the Nios II processor.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Current-To-Frequency Converter
    Computer Microphone Circuit
    optocouplers safely isolate integrated power modules
    fm antenna booster circuit
    avr programmer how to make
    light activated led scr
    PLL1706DBQ 3.3-V DUAL PLL MULTICLOCK GENERATOR
    SP6336 SP6336 -Triple Micropower Supervisory Circuit With Watchdog And Power Fail
    555 consisting of portable electronic timing hypnosis massage
    Thermocouple cold junction compensator AD596 597 a circuit diagram of Temperature Monitor



    Top