Wien bridge oscillator circuit


Posted on Feb 7, 2014

In this laboratory experiment, we need to design the frequency determining network for a 1k Hz sinusoidal oscillator. Therefore, we should set: Capacitance = 100nF Resistance = 1520 ohm


Wien bridge oscillator circuit
Click here to download the full size of the above Circuit.

Output voltage waveform of oscillator with varying the value of R1:

Set R1 = 2033 ohm  (The loop gain is about to 1, sustained oscillation is resulted.)

Ser R1=2.1k ohm (The loop gain is greater than 1, overdamping oscillation is resulted.)

Set R1= 1.9k ohm (The loop gain is smaller than 1, underdamping oscillation is resulted.)





Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

one wire keypad with PIC16F88
Advanced Telephone Intercom
humidity sensor circuit
Variable-Voltage Reference Source
Dc Output Chopper Circuit
water level indicator circuit using cmos ics
H-Bridge Motor Driver using MOSFETs and Transistors
8PhotoNonInverting
crystal base oscillator circuit
Simple applications of neon glow lamps
Icom IC-751 (IC 751 IC751) transceiver mods reviews software and diagrams
Improving the MICOR Receiver for 435-450 MHz
1 mA CURRENT SINKl
ELECTROMAGNETIC RING LAUNCHER
SI ABBREVIATION DISPLAY
The use of low-power tube amp tube radios restructuring
Controllable integrator F007 schematic



Top