temperature controller using ds1820 and lcd display


Posted on Feb 6, 2014

This Project is used to indicate the temperature and it is also used as controller. The system will get the temperature from the DS1820 and it will display the temperature over the LCD display. There are 2 preset levels, one is low preset and the other is High preset. The temperature was compared with the value stored by the user and if the temper


temperature controller using ds1820 and lcd display
Click here to download the full size of the above Circuit.

ature goes beyond the High Preset temperature then an relay is switched ON until the temperature comes below the Low preset temperature. The System is fully controlled by the microcontroller AT89S52. It is a popular 8 bit microcontroller. The circuit consists of four switches, in which two buttons are used to increment and decrement the High limit temperature value and the other two buttons are used to increment and decrement the Low limit temperature value. The temperature limits are stored inside the EEPROM, since 89s52 dont have inbuilt eeprom. The IC 24C02 is the eeprom chip and it is connected to the microcontroller through the I2C bus. The DS1820 is the temperature sensor chip which is connected to the microcontroller through 1 wire bus.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Colpitts harmonic oscillator 100Mhz
Butler aperiodic oscillator
Random timer circuit using a Attiny24A
Dean Forest Railway Telecoms
LTC1042 wind charger circuit schematic project
Master/Slave Switch
infrared extending IR range
Harnessing Solar Power with Smart Power-Conversion Techniques
Servo Motor Control Circuit
Moving Sensor / Detector Schematic Diagram using IC NE555 and Phototransistor L14F



Top