DTL-TTL controlled buffered analog switch
The analog switch circuit described incorporates the 2N4860 JFET, known for its excellent performance in low-resistance applications. The JFET's on-resistance (ron) of 25 ohms ensures minimal signal loss when the switch is in the closed position, making it suitable for precision signal routing in various electronic applications. The low leakage current characteristic of the 2N4860 further enhances the circuit's reliability, particularly in applications where signal integrity is paramount.
The use of the LM102 as a voltage buffer is crucial for isolating the input signal from the output, thereby preventing loading effects that could distort the signal. This buffer allows for a stable voltage level to be maintained across the switch, ensuring that the output accurately reflects the input without degradation.
The versatility of the circuit is highlighted by its adaptability for use in a dual trace oscilloscope chopper. In this application, the analog switch can be employed to alternate between two input signals, allowing for simultaneous observation of both signals on a single display. This capability is especially useful in troubleshooting and analyzing complex waveforms in electronic circuits.
The DS7800 monolithic IC plays a key role in driving the analog switch. It is designed to interface seamlessly with DTL (Diode-Transistor Logic) and TTL (Transistor-Transistor Logic) logic levels, making it compatible with a wide range of digital circuits. The DS7800 provides the necessary control signals to activate the 2N4860 JFET, ensuring that the switch operates reliably within the specified logic levels.
Overall, this analog switch circuit is characterized by its low on-resistance, minimal leakage, and adaptability for various applications, including dual trace oscilloscopes. The combination of the 2N4860 JFET, LM102 voltage buffer, and DS7800 IC creates a robust solution for precise signal management in electronic systems.This analog switch uses the 2N4860 JFET for its 25 ohm ron and low leakage. The LM102 serves as a voltage buffer. This circuit can be adapted to a dual trace oscilloscope chopper The DS7800 monolithic IC provides adequate switch drive controlled by DTL/TTL logic levels.
Related Circuits
A phase-locked loop (PLL) is widely utilized in telecommunications, control systems, and various other electronic applications. PLLs can be employed to demodulate frequency-modulated (FM) signals and generate a stable output frequency. A phase-locked loop is an essential feedback control system...
This typical circuit utilizes an external operational amplifier for improved performance, along with an exponential converter to achieve a control characteristic of -6 dB per volt. Trim networks are incorporated to eliminate distortion and offset, as well as to...
4QD manufactures motor speed controllers, and all their H bridges utilize PWM. This is a simple switch circuit designed for reversing and stopping a motor without speed control. Two inputs, A and B, control the bridge. When both inputs...
This circuit can switch two or more devices on and off in response to a series of rapid handclaps. The claps are detected by an electret microphone and amplified by a 741 operational amplifier (IC1). IC1 is configured as...
This schematic diagram below shows a circuit of a VOX Box (voice-operated switch). This circuit consists of a Schmitt trigger, a relay driver, and a microphone. The VOX Box circuit operates as a voice-activated switch, utilizing a microphone to detect...
Typically, home appliances are controlled using switches, sensors, and similar devices. However, physical contact with switches can pose risks, especially in the event of a short circuit. The circuit outlined here eliminates the need for physical contact to operate...