Mullard EL34 Push-Pull Tube Amp Schematic (Dynaco A420 Transformer)
The Mullard EL34 push-pull vacuum tube amplifier is a classic audio amplification circuit that utilizes EL34 vacuum tubes in a push-pull configuration to deliver high-quality sound reproduction. This design is particularly noted for its warm tonal characteristics and dynamic range, making it a favored choice among audiophiles. The amplifier employs Dynaco A420 audio output transformers, which are integral to the output stage, ensuring efficient power transfer and minimal distortion.
In this schematic, the EL34 tubes are arranged in a push-pull configuration, where one tube amplifies the positive half of the audio signal while the other amplifies the negative half. This arrangement helps to cancel out even-order harmonics, resulting in a more linear output and improved sound quality. The use of feedback in the circuit further enhances the amplifier's performance by reducing distortion and improving frequency response.
The power supply section typically includes a high-voltage transformer, rectifier, and filter capacitors to provide the necessary DC voltage for the tubes. The Dynaco A420 output transformers are designed to match the impedance of the EL34 tubes with that of the loudspeakers, optimizing the power transfer and ensuring that the amplifier can drive a range of speaker loads effectively.
Signal coupling is usually achieved through capacitors that block DC while allowing the AC audio signal to pass. Biasing resistors and capacitors are employed to set the operating point of the EL34 tubes, ensuring they operate within their optimal range for maximum performance. Additionally, the circuit may include various components such as resistors, potentiometers, and additional capacitors to fine-tune the amplifier's response and user controls.
Overall, the Mullard EL34 push-pull vacuum tube amplifier schematic represents a well-engineered design that combines classic tube technology with modern audio performance standards, making it a timeless solution for high-fidelity audio applications.Mullard EL34 push-pull vacuum tube amplifier scheamtic using Dynaco A420 audio output transformers 🔗 External reference
Related Circuits
A schematic diagram of a micropower single-supply instrumentation amplifier circuit is presented. This circuit requires only 15µA of current and can provide over... The micropower single-supply instrumentation amplifier circuit is designed for applications where low power consumption is critical. The amplifier...
Although the basic amplifier circuit phase AC amplifier remains unchanged, the selection of the correct gain requires the use of series resistors. The circuit does not include a 9kΩ resistor. The input amplifier Ai selected is the OP37, which...
This chapter includes circuit diagrams for various power supplies designed for pulsed solid-state lasers. It features units that are compatible with the widely used Hughes ruby and YAG rangefinder laser assemblies, one utilizing the flash from a disposable pocket...
This project utilizes a single tube, specifically the 13EM7, which contains two distinct triode structures. The first structure is compact and provides substantial signal gain but limited power, making it suitable for a preamplifier stage. The second structure is...
The amplifier circuit utilizes negative current feedback, which ensures that the load current is primarily influenced by the input signal rather than the loudspeaker's impedance. The inductor current from the loudspeaker generates a voltage across resistor R7, which is...
This simple 12-volt halogen lamp soft starter circuit extends the life of the halogen lamps by eliminating the sharp rise in the temperature of the filament. The 12-volt halogen lamp soft starter circuit is designed to mitigate the initial surge...