9 Volt 2 Amp PSU with 78S09

Posted on Jul 21, 2012

The circuit will work without the extra components, but for reverse polarity protection a 1N5400 diode is provided at the input, extra smoothing being provided by C1. The output stage includes C2 for extra filtering, if powering a logic circuit than a 100nF capacitor is also desirable to remove any high frequency switching noise.

9 Volt 2 Amp PSU with 78S09
Click here to download the full size of the above Circuit.

There is little to be said about this circuit. All the work is done by the regulator. The 78S09 can deliver up to 2 amps continuous output whilst maintaining a low noise and very well regulated supply.

Leave Comment

characters left:

New Circuits



Popular Circuits

Bit Bender
High-accuracy ultrasonic range measurement system because of ߀?s C OS and ARM processor
tesla circuit
Low pass filter circuit 10KHz using uA741
4bit alphanumeric LCD interface 8051
Solar Water Heating Pump Controller
NTC protection circuit three-phase asynchronous motors
1kHz square wave signal source circuit