Arduino GSM GPRS and GPS shield
No description available.
Related Circuits
If the ground of the Arduino is disconnected from the negative terminal of the power supply, current flows through the MOSFET, even when the switch is not closed. In an electronic circuit involving an Arduino and a MOSFET, maintaining a...
The device utilizes a GSM/GPRS module that includes GPS functionality. Its primary purpose is to detect and communicate its geographical position using either the cellular phone reference system or GPS. The compact design is attributed to the integration of...
MRFICl505R2 is a 1.575GHz GPS downconverter chip. It integrates a mixer, VCO, PLL, crystal oscillator, A/D converter, loop filter, and other circuits. The MRFICl505R2 IF output frequency is 4.1MHz, with a typical conversion gain of 105dB, an operating voltage...
It is advisable to modify inexpensive USB speakers to obtain a pre-assembled analog front-end for this project. If this is not feasible, then soldering will be necessary, requiring a minimum of two resistors and one capacitor, assuming the display...
The parts list referenced is from the first page of a Make Magazine article. This list is intended for a harp that utilizes six lasers, so most quantities can be simplified to one. The schematic design based on the described...
The advanced credit card, referred to as the "microcontroller super card," incorporates numerous innovative enhancements. The initial step involved verifying the code and subsequently uploading it to the Arduino board. The developed code enabled a counter to increment from...