3 band equalizer


Posted on Feb 7, 2014

This is a simple 3 band graphic equalizer circuit that`s built by a single op amp IC LF351 IC and few passive components. The component values of this circuit are not very critical and can be replaced with nearest values with a little loss on the performance. This is feature make it easy to be assembled from your junk box. This is a figure of the


3 band equalizer
Click here to download the full size of the above Circuit.

circuit; How is the simple 3 band graphic equalizer work The op amp LF351 is wired to operate in three frequency ranges-high, medium and low. The circuit is designed such that the circuit produces +/-20 dB boost or attenuation for 50Hz, 1KHz and 10Khz by varying POT`s R3, R6 and R9. The maximum amplification for any of these bands at maximum supply voltage is 20dB. The op amp LF 351 is wired as an inverting amplifier whose response to frequencies 50Hz, 1Khz and 10KHz can be varied by adjusting POT`s R3, R6 and R9.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Wireless doorbell 300MHz
    MIDI tester circuit
    Electronic thermometer
    40Mhz-universal-counter
    MOSFET IRF510 Capacitor Discharge Ignition(CDI) Circuit and explanation
    Audio VU meter with Extra wide Dynamic Range 69 dB using Arduino
    555 Timer as Monostable Multivibrator
    Hall Effect Sensors Magnetic Field
    S53MV Notune SSB giga radio set
    Successive Approximation ADC
    Modular Phono Preamplifier
    YD9088 FM RECEIVER CIRCUIT FOR BATTERY SUPPLY
    ZX Interface 2
    Autodyne Circuit
    Timing SCR control motor reversing circuit
    Basic circuit diagram connection of signal and power INA166



    Top