PLL FM Demodulator Circuit Module


Posted on Feb 5, 2014

This is a circuit about PLL system that can be used to implement an FM demodulator. Since the VCO output tracks the FM signal, and the VCO input voltage is proportional to the VCO output frequency, then the VCO input will be equal to the demodulated signal. This circuit is based on phase comparator and VCO. This is the figure of the circuit. For t


PLL FM Demodulator Circuit Module
Click here to download the full size of the above Circuit.

his example, an FM signal consisting of a 10-kHz carrier frequency was modulated by a 400-Hz audio signal. The schematic diagram shows the connections of the CD4046B as an FM demodulator. The total FM signal amplitude is 500 mV, therefore, the signal must be ac coupled to the signal input (terminal 14). Phase comparator I is used for this application because a PLL system with a center frequency equal to the FM carrier frequency is needed. Phase comparator I lends itself to this application also because of its high signal-input-noise-rejection characteristics.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Ramp generator
    Staircase-generator
    Guitar Schematics
    Serial Interface LCD circuit
    Bldc Motor Control Kit With Ata6833/ Ata6834
    Parallel port programming
    The STA013 MP3 Decoder Chip
    Backup Lamp Circuit
    2-5-cell lithium battery charger circuit
    LB1416 36 five sections and Ten-segment level display a
    Enhanced AE1169 made lock circuit diagram



    Top