light flasher/blinker circuit diagram


Posted on Feb 7, 2014

With the preset at its max. the flashing rate of the LED is about 1/2 a second. It can be increased by increasing the value of the capacitor from 10uF to a higher value. For example if it is increased to 22uF the flashing rate becomes 1 second. There is also provision to convert it into an alternating flasher. You just have to connect a LED and a


light flasher/blinker circuit diagram
Click here to download the full size of the above Circuit.

330ohm as shown in Fig. 2 to the points X and Y of Fig. 1. Then both the LEDs flash alternately. Since the 555 can supply or sink in upto 200mA of current, you can connect upto about 18 LEDS in parallel both for the flasher and alternating flasher (that makes a total of 36 LEDs for alternating flasher).




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Low-forward-drop-rectifier-circuit
    Programmable Identifier
    radio transmission to get the GPS data
    Electronic Keypad Combination Lock
    syntha vcf historical
    automotive
    GPS reference clock NTP server with Gentoo
    The Technology of the Tube Screamer
    Long Delay Timer Circuit
    IC Controlled Emergency Light With Charger Circuit
    RF VOLTMETER
    Garden Railway Sensors
    Dimming circuit using capacitance
    Photoresistor LDR light control switch circuit diagram
    Output by the CS3843 and CS5101 composed of 5V 3.3V switching DC power supply circuit



    Top