Passive subwoofer filter
The described circuit is a passive low-frequency filter designed to enhance audio output by directing specific frequency ranges to a subwoofer. This filter operates without an external power supply, making it ideal for integration into existing audio systems. The primary function of this filter is to attenuate frequencies above 150 Hz, allowing lower frequencies to pass through to the subwoofer.
The circuit utilizes standard passive components such as resistors, capacitors, and a variable potentiometer, specifically a 2.2 kΩ potentiometer, which enables users to adjust the cutoff frequency. This adjustment allows for flexibility in tuning the filter to accommodate different audio setups and preferences. The range of frequency adjustment is between 50 Hz and 160 Hz, making it suitable for various audio applications.
Designed to work optimally with a 50-watt audio amplifier, the circuit can also handle higher power levels, ensuring that it can be adapted for use with more powerful audio amplification systems. The passive nature of the filter means it does not introduce additional noise or distortion into the audio signal, preserving the integrity of the sound while effectively managing the frequency response.
In summary, this low-frequency passive filter is a practical solution for individuals seeking to enhance their audio systems by adding a subwoofer, providing a straightforward means to control and optimize low-frequency performance without the complexity of active circuits.The schematic shown, does no need any power supply because is a simple low frequency passive filter. It could be usefull if you want to drive an extra subwoofer from your stereo system.
The circuit filters the frequency ranges above the 150Hz. The schematic is calculated to work with a 50 watts audio amplifier, but can be used with higher powers as well. The frequency can be adjusted with 2k2 potentiometer from 50 Hz to 160 Hz.
🔗 External referenceRelated Circuits
The figures below illustrate using opamps as active 2nd order filters. Three 2nd order filters are shown, low pass, high pass, and bandpass. Each of these filters will attenuate frequencies outside their passband at a rate of 12dB per...
Frequency-Shift Keying (FSK) is a type of frequency modulation where the modulating signal alters the output frequency between specific predetermined values. When issues occur during the demodulation of FSK signals, utilizing an FSK filter circuit can be beneficial. Frequency-Shift Keying...
A twin-T network is connected to an LM102 to create a high-Q, 60 Hz notch filter. The junction of R3 and C3, typically grounded, is bootstrapped to the follower's output. The low impedance of the follower ensures that neither...
Electronics tutorial about passive high pass filter circuit, including passive RC high pass filter first order frequency response, Bode plot, and construction. The passive high pass filter circuit is an essential component in electronics, designed to allow signals with a...
A standard dual integrator filter can be constructed using a few CA3080 operational amplifiers. By varying the parameters L, A, B, and C, the resonant frequency can be swept over a range of 1000:1. At IC1, three current-controlled integrators...
The amplifier circuit is well-suited for use in subwoofer speakers due to its robust performance. This circuit utilizes an integrated circuit (IC) based on the STK series. It can be employed in vehicles equipped with speakers or a subwoofer...