Stereo Channels Controller

The circuit includes better channel separation, resulting in an increased stereo effect, as well as reduced noise and hum. This schematic will allow you to cancel or blend left and right channels of your stereo. Uses the LM4136 but at the circuit is a 741 opamp. The control potentiometer needs to be a dual ganged center tapped control. As an alternative, a dual ganged switch can be used and appropriate resistors added. See insert with a 12 position switch, each resistor will be a 3k6 ohm resistor. Total resistance = 39K. Other resistors can be used, if ratios remain constant.

The circuit is designed to enhance audio performance by providing improved channel separation, which is critical for stereo applications. The use of the LM4136, a low-noise operational amplifier, provides a robust foundation for the circuit, although the implementation utilizes the 741 operational amplifier for signal processing. The 741 op-amp is a widely used component known for its versatility in audio circuits.

The dual-ganged center-tapped potentiometer serves as the primary control element, allowing users to adjust the blend between the left and right audio channels. This configuration enables fine-tuning of the stereo effect, enhancing the listening experience. In cases where a potentiometer is not available, a dual-ganged switch can be employed, which would require the addition of fixed resistors to maintain the desired channel balance.

The schematic specifies the use of a 12-position switch, with each position incorporating a 3.6 kΩ resistor. This setup results in a total resistance of 39 kΩ, ensuring that the audio signal remains within acceptable levels while providing the necessary control over channel blending. It is important to note that alternative resistor values can be utilized, provided that the ratios between them are preserved to maintain the intended functionality of the circuit.

The overall design emphasizes the reduction of noise and hum, which is crucial in audio applications. By implementing careful layout techniques and selecting high-quality components, the circuit can achieve a cleaner audio output with minimal interference. Proper grounding and shielding practices should also be considered to further enhance performance and reliability in real-world applications.The circuit includes Better channel separation, resulting in an increased stereo effect, as well as reduced noise and hum. This schematic will allow you to cancel or blend left and rigth channels of your stereo. Uses the LM4136 but at the circuit is a 741 opamp. The control potentiometer needs to be a dual ganged center tapped control. As an alternative, a dual ganged switch can be used and appropriate resistors added. See insert with an 12 position switch, each resistor will be a 3k6 ohm resistor. Total resistance = 39K. Other resistors can be used, if ratios remain constant. 🔗 External reference