Two-channel speaker protection schematic


Posted on Mar 28, 2007

As shown for the speaker protection circuitry. It is designed for the left and right channels operate independently. The figure (to the left channel as an example) of R2, C4 an


Two-channel speaker protection schematic
Click here to download the full size of the above Circuit.

d VT2, VT3 composition start delay circuit to prevent power current shock speaker. Component selection: LED high brightness can be used µ3mm two-color LED. Since the LED current big and small, R5, R9 parameters may be slightly adjusted. At the same time, LED and current limiting resistor R5, R9 because in parallel relay RE1, RE2 ends, but also restrain the anti-peak voltage to prevent breakdown VT2, VT3 and VT5, VT6. C4, C9 best selection of low-leakage tantalum capacitors.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Telephone Intercom - DTMF
HF 1-30MHz linear amplifier
Strobo triggering schematics
Windshield wiper hesitation control unit
Directional-signals-monitor
Non-integer-programmable-pulse-divider
Lighted-display-brightness-control
6W Morse-Code Transmitter 7Mhz Circuit
make this simple delay on timer circuit
Audio VU Meter
230 V 50Hz AC (or 110V 60Hz) Main Operated LED Powerful NIGHT LAMPCircuit
Microcontroller and Motor Driver Circuit Board
Three of the five band equalizer circuit transistor



Top