ONE FILTER THREE PHASE SINE WAVE GENERATOR


Posted on Feb 5, 2014

It is possible to build a three-phase sine-wave oscillator using just one UAF42 state variable filter along with some resistors and diodes. Three output nodes are available: high-pass out, bandpass out, and low-pass out. The signals at the bandpass and low-pass out nodes are 90 °and 180 ° out of phase, respectively, with those at the high-pass out


ONE FILTER THREE PHASE SINE WAVE GENERATOR
Click here to download the full size of the above Circuit.

node. An on-board auxiliary op amp is available for use as a buffer or gain stage. The frequency of oscillation is set with resistors RF1 and RF2 using the simple equation:




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    8 Channel software controlled for PC fan
    Chua's Oscillator circuit
    High Voltage power Supply
    Telephone Ringer using 556
    Low-frequency oscillator 10-150khz
    Audio Mixer
    Simple Telephone Ring Tone Generator Circuit schematic with explanation
    Automatic blind hooked up to existing projector screen using Arduino
    12v to 5v converter
    sequential timer
    Schematic of the endoelectronics Biotechnology
    Simple Pyro RF Receiver (27 MHz) - Signal Mixing
    Operational Amplifiers circuits
    High resolution dithering bar graph display
    SEISMIC RADIO 500mHz - 200Hz frequency range
    TDA4866 test circuit diagram
    Extended delta decompression starter control circuit



    Top