The circuit will modulate the light from the LED using a crystal microphone or a loudspeaker...
This circuit is basically an op amp with an nal (±10 mV) between pin 2 and 3 and by extra input...
If a NiCad battery is discharged to a point at which the lowest capacity cell becomes fully...
This system contains an IR transmitter, an IR receiver/RF transmitter, and an RF receiver/alert...
Connect three wires to the Arduino board. The first two, red and black, connect to the two long...
This circuit is a simple dual simplex to half-duplex driver for 1-wire devices, although it does...
The electronic lantern control circuit adds high-efficiency dimming and flashing to an existing...
For those who are lazy like me, turn on or off the bedroom light without getting out of bed,...
There are situations in which very long cable runs are necessary from the pedalboard to the...
As shown, the circuit is powered by a 9-V battery, B1, but it can easily run off any 7- to 10-Vdc...
This circuit features an intermittent siren output and automatic reset. It can be operated...
As shown below, it is a circuit diagram of a portable gas detector. The portable gas detector...